|
IMGA0634
Shimmed for correct washout
Date: 04/14/2013
Views: 7794
|
|
|
IMGA0716
Cracked off the jig, flipped over, and there we go iv got half a wing!!
Date: 04/23/2013
Views: 7282
|
|
|
IMGA0673
Nicely shaped and blended in. The pipe sticking out runs all the way through the blocks and is to carry the wires from the fuselage to the wing tips for nav/strobe and hopefully landing lights
Date: 04/18/2013
Views: 7227
|
|
|
IMGA0750
Made a tube of bid to carry the pitot tubes from one block to another. This block is where the bell crank sits and the push rod goes to the aileron.
Date: 05/05/2013
Views: 7619
|
|
|
IMGA0585
Date: 03/18/2013
Views: 10908
|
|
|
IMGA0680
These are the rear blocks where the bell cranks sit in. Note the vent holes
Date: 04/18/2013
Views: 7362
|
|
|
IMGA0756
Some dry micro to stick the block to the spar
Date: 05/05/2013
Views: 7202
|
|
|
IMGA0737
The small bloke with two mounting plates at the outrigger position.
Date: 04/26/2013
Views: 7607
|
|
|
IMGA0623
Date: 04/09/2013
Views: 8676
|
|
|
IMGA0572
Date: 03/17/2013
Views: 9238
|
|
|
IMGA0581
Date: 03/18/2013
Views: 10537
|
|
|
IMGA0571
Date: 03/17/2013
Views: 25894
|
|
|
IMGA0660
You can see the wash out build into the block
Date: 04/17/2013
Views: 7235
|
|
|
IMGA0820
Aileron closeout
Date: 05/15/2013
Views: 9768
|
|
|
IMGA0661
Screws through ribs to align blocks.....must remember to remove them before the lay up
Date: 04/17/2013
Views: 6882
|
|
|
IMGA0626
Hole ready for stall warner
Date: 04/11/2013
Views: 8171
|
|
|
IMGA0664
Scrap bit of foam which will get sanded to match the profile of the block. It takes up the gap between spar and end of the block
Date: 04/17/2013
Views: 7538
|
|
|
IMGA0573
Date: 03/17/2013
Views: 10245
|
|
|
IMGA0800
all that work then you have to cut a big chunk out!!
Date: 05/13/2013
Views: 7817
|
|
|
IMGA0785
One side done. A straight edge is bonded on to aid rigidity once some of the foam is cut away
Date: 05/12/2013
Views: 8005
|
|