|
IMG_7559ann
This is the Billet regulator with the two new adaptors. When I return from India, I shall get back to work on both the brake modifications and the installation of the Billet pump and regulator.
Date: 04/30/2010
Views: 3714
|
|
|
IMG_6973post
Pointing out areas relieved for fit over swing arm
Date: 12/27/2009
Views: 3209
|
|
|
Intercooler07
Date: 01/07/2006
Views: 4193
|
|
|
IMG_0920post
Some pics after the engine run-up and taxi tests today.
Date: 07/01/2010
Views: 4968
|
|
|
IMG_6975post
Overall length of ramp
Date: 12/27/2009
Views: 3452
|
|
|
IMG_2862Ann
Date: 12/06/2008
Views: 3358
|
|
|
IMG_0888post
This is the Grove brake caliper I am using. It may not be the perfect replacement for the Europa brake but it sure works. I've e-mailed Robby at Grove and asked if he'd like me to send the old Europa brake caliper to see if they have a better replacemen
Date: 06/29/2010
Views: 3141
|
|
|
IMG_2857
Date: 12/03/2008
Views: 3488
|
|
|
IMG_9572post
Made sure that the vent line was attached and run to the back and down into the area below the engine, but not into the air stream.
Date: 06/12/2010
Views: 3739
|
|
|
IMG_1093ann
Finally, problem #3 - 3/8" hose barb input and 1/4" hose barb output. There is an issue locating a 1/4" hose barb banjo to attach to the Rotax fuel pressure regulator.
Date: 04/03/2010
Views: 3807
|
|
|
IMG_6789small
Date: 02/23/2008
Views: 3563
|
|
|
IMG_6782small
Date: 02/23/2008
Views: 3193
|
|
|
IMG_0044post
So it's back to bleeding the brakes again. Pull the lines out so there's no high spots and there's an "all up" run to the master cylinder. Connect the bleed contraption and wait.
Date: 07/08/2010
Views: 3640
|
|
|
P4141325
Date: 04/16/2006
Views: 3816
|
|
|
Intercooler05
Date: 01/07/2006
Views: 4026
|
|
|
IMG_6682Ann
Date: 02/15/2008
Views: 3572
|
|
|
DSCN6101Ann
Date: 06/13/2007
Views: 3927
|
|
|
3_snaps
The original snap base hardware is on the right. The new snap bases and mounting hardware are on the left. These 6-32 screw mount snap bases are from McMaster-Carr. I used big ol' AN970 washers for more support underneath and nyloc nuts so they don't c
Date: 06/23/2011
Views: 4182
|
|
|
IMG_1087ann
Then problem #2 - bolts that held the cover plate in place wouldn't fit into the space provided on the pump.
Date: 04/03/2010
Views: 3692
|
|
|
Condition Inspection P1 T
Date: 02/04/2010
Views: 3123
|
|