|
dsc09066
Port side peel ply removed. Oh notice the caps in the sockets. What I did was take a block of foam and push it down in the socket, then took it back out and covered it with car wax. Once all the ribs are in I'll see how it worked.
Date: 01/25/2013
Views: 8363
|
|
|
p1000634
p1000634.jpg
Date: 02/14/2012
Views: 6803
|
|
|
dsc08609
Underside of vents.
Date: 04/10/2012
Views: 12505
|
|
|
nex_2014_01_25_06
Mains on the ground for the first time.
Date: 01/25/2014
Views: 7220
|
|
|
Close up of the relief cut.
Close up of the relief cut.
Date: 04/03/2016
Views: 13669
|
|
|
p1000703
p1000703.jpg
Date: 03/12/2012
Views: 5899
|
|
|
p1000708
p1000708.jpg
Date: 03/12/2012
Views: 5903
|
|
|
p1000706
p1000706.jpg
Date: 03/12/2012
Views: 5992
|
|
|
p1000635
p1000635.jpg
Date: 02/14/2012
Views: 6646
|
|
|
p1000715
p1000715.jpg
Date: 03/12/2012
Views: 6646
|
|
|
dsc09065
Stbd side peel ply removed.
Date: 01/25/2013
Views: 8557
|
|
|
dsc08403
Bill helping me out!
Date: 03/25/2012
Views: 9430
|
|
|
nex_2014_01_12_05
Port side top.
Date: 01/13/2014
Views: 7041
|
|
|
photo (1)
Bad pic, but shows the end of the reinforcement layups (port side).
Date: 08/20/2012
Views: 12328
|
|
|
dsc09064
Bill does nice peel ply work!
Date: 01/24/2013
Views: 8133
|
|
|
nex_2014_01_25_02
Starboard side of the air bubble fix on rib one. Used Flox with aeroboxy as a fillit.
Date: 01/25/2014
Views: 7265
|
|
|
dsc09036
Rib one port side again used around 112g of 420 cured at 78f for 12 hours.
Date: 01/23/2013
Views: 8159
|
|
|
p1000687
p1000687.jpg
Date: 03/12/2012
Views: 6728
|
|
|
20141102_161036
Everything looking good.
Date: 11/02/2014
Views: 14880
|
|
|
DSC08803
Me and my Uncle Kim.
Date: 06/10/2012
Views: 10381
|
|