|
IMG_0394
Date: 04/10/2015
Views: 8765
|
|
|
DSC00158
Date: 09/03/2015
Views: 12901
|
|
|
DSC00157
Instructions state that rod should be reamed to 0.375" but it needed to be reamed out 0.428" to fit push rod.
Date: 09/03/2015
Views: 8797
|
|
|
IMG_0406
Date: 04/17/2015
Views: 9055
|
|
|
DSC00212
Marking position for bracket on rear bulk head
Date: 09/08/2015
Views: 12976
|
|
|
IMG_0235
Date: 02/01/2014
Views: 9448
|
|
|
IMG_0229
At Steve's workshop packing the kit ready for transportation
Date: 01/31/2014
Views: 9437
|
|
|
IMG_0187[1]
Started to fit fixtures and fittings
Date: 04/13/2014
Views: 11888
|
|
|
Rivets
Next problem. Once the push rod end was fitted and drilled according to the manual the rivets provided were too short to go through the whole structure. Awaiting a response from Europa
Date: 09/03/2015
Views: 8723
|
|
|
IMG_0821
Trial fitted the torque tube but it looks like the TP38 bearing is too short!
Date: 09/03/2015
Views: 7762
|
|
|
DSC00228
Had to remove more of the rudder than I wanted so build up rudder trailing edge by attaching peel ply to the outside of the rudder and build up trailing edge using flox around the edge and an initial 2 ply of bid. i'll apply an additional 2 ply after the
Date: 09/10/2015
Views: 8545
|
|
|
IMG_0409
Date: 04/17/2015
Views: 8798
|
|
|
DSC00163
Rudder opened up to accept the push rod bracket. Alas no blue foam as it is the NG model. No instructions on how to proceed. Advice from Europa is to bod in some blue foam is it is not load bearing and is just a bed for the composite.
Date: 09/04/2015
Views: 10568
|
|
|
IMG_0823
Same of port side.
Date: 09/03/2015
Views: 7822
|
|
|
DSC00229
Still some work to do but happy so far.
Date: 09/10/2015
Views: 13081
|
|
|
IMG_0231
Date: 01/31/2014
Views: 9984
|
|
|
Ipad 041
Shed Under construction
Date: 03/27/2014
Views: 8969
|
|
|
DSC00155
As you can see the Issue 1 Bearings are considerably longer and will require shortening once I have the correct dimensions.
Date: 09/03/2015
Views: 7944
|
|
|
IMG_0187.JPG (2)
Workshop kitted out. All done in 3 weeks!
Date: 04/13/2014
Views: 11096
|
|
|
IMG_0400
Date: 04/14/2015
Views: 9383
|
|