|
IMGA0737
The small bloke with two mounting plates at the outrigger position.
Date: 04/26/2013
Views: 7363
|
|
|
IMGA0750
Made a tube of bid to carry the pitot tubes from one block to another. This block is where the bell crank sits and the push rod goes to the aileron.
Date: 05/05/2013
Views: 7452
|
|
|
IMGA0572
Date: 03/17/2013
Views: 9049
|
|
|
IMGA0770
Two are a time baby yeah!!!!!
Date: 05/10/2013
Views: 7555
|
|
|
IMGA0641
EXOTHERM!! My worst moment yet
Date: 04/16/2013
Views: 7486
|
|
|
IMGA0785
One side done. A straight edge is bonded on to aid rigidity once some of the foam is cut away
Date: 05/12/2013
Views: 7816
|
|
|
IMGA0754
These straps are great, one down one to go
Date: 05/05/2013
Views: 7494
|
|
|
IMGA0657
After repair
Date: 04/17/2013
Views: 7647
|
|
|
IMGA0664
Scrap bit of foam which will get sanded to match the profile of the block. It takes up the gap between spar and end of the block
Date: 04/17/2013
Views: 7332
|
|
|
IMGA0573
Date: 03/17/2013
Views: 10008
|
|
|
IMGA0585
Date: 03/18/2013
Views: 10689
|
|
|
IMGA0623
Date: 04/09/2013
Views: 8467
|
|
|
IMGA0707
The next day me and my helper Ang did the other wing. This time it only took 6 and half hours so left us time to trim the other wing
Date: 04/21/2013
Views: 7290
|
|
|
IMGA0756
Some dry micro to stick the block to the spar
Date: 05/05/2013
Views: 7011
|
|
|
IMGA0626
Hole ready for stall warner
Date: 04/11/2013
Views: 7941
|
|
|
IMGA0800
all that work then you have to cut a big chunk out!!
Date: 05/13/2013
Views: 7606
|
|
|
IMGA0624
Date: 04/11/2013
Views: 8368
|
|
|
IMGA0820
Aileron closeout
Date: 05/15/2013
Views: 9524
|
|
|
IMGA0661
Screws through ribs to align blocks.....must remember to remove them before the lay up
Date: 04/17/2013
Views: 6688
|
|
|
IMGA0878
Wing rib close outs
Date: 05/30/2013
Views: 8545
|
|