|
dsc09069
Rib 2 stbd side.
Date: 01/25/2013
Views: 9507
|
|
|
p1000632
p1000632.jpg
Date: 02/14/2012
Views: 8446
|
|
|
dsc09021
BIG THANK YOU to my Uncle Kim Prout for flying out to help me with getting the gear legs set. He also helped me slow down and plan ahead. As an excited new builder its easy to get in a rush to try achieve something tangible. Im sure after that week of b
Date: 01/22/2013
Views: 9303
|
|
|
dsc08610
Whats missing?
Date: 04/10/2012
Views: 8884
|
|
|
p1000698
p1000698.jpg
Date: 03/12/2012
Views: 7163
|
|
|
dsc09068
Seeing how ribs 2,3,4 line up. Get a belt sander 4x36, you'll be glad you did. Mine is from Harbor Freight.
Date: 01/25/2013
Views: 10026
|
|
|
p1000615
p1000615.jpg
Date: 01/29/2012
Views: 10018
|
|
|
dsc09027
Mixing that expensive 420.
Date: 01/22/2013
Views: 9040
|
|
|
dsc08960
Stb side after layups and peel ply removed.
Date: 10/01/2012
Views: 12385
|
|
|
dsc08612
Unused Mono wheel components. I'll probably be selling these soon.
Date: 04/10/2012
Views: 12550
|
|
|
nex_2013_08_24_04
As you see here the port side is done with rib 3 and 4. I didn't have photos of doing the layups.
Date: 08/25/2013
Views: 7976
|
|
|
DSC08799
Port side
Date: 06/05/2012
Views: 10135
|
|
|
dsc09022
Here you see I used bondo on the shims and screwed them down into the block. The shims made sure the guide was level. Also note the hole drilled in the Aluminum angle and the shim. This is where I fixed the guide for the curing stage to ensure nothing
Date: 01/22/2013
Views: 9844
|
|
|
Close up of the relief cut.
Close up of the relief cut.
Date: 04/03/2016
Views: 14187
|
|
|
p1000727
p1000727.jpg
Date: 03/12/2012
Views: 6431
|
|
|
20141102_153539
Out. Ad you can see the screw is sill in the nut plate. it came out later.
Date: 11/02/2014
Views: 19153
|
|
|
2012-08-18_19-58-15_689
Port side. Red highlighted area shows area with little reinforcement on inside. This is before I did the belly layup per the manual.
Date: 08/19/2012
Views: 11580
|
|
|
Wanted to make a copy of B16 to make the cuts on before I cut the actual B16 part.
Wanted to make a copy of B16 to make the cuts on before I cut the actual B16 part.
Date: 04/03/2016
Views: 14732
|
|
|
p1000710
p1000710.jpg
Date: 03/12/2012
Views: 6383
|
|
|
photo (1)
Bad pic, but shows the end of the reinforcement layups (port side).
Date: 08/20/2012
Views: 13146
|
|