|
Flap Mark Up
So it was time to commit to sticking the real markings to the flap. Flap up...
Date: 07/01/2011
Views: 3820
|
|
|
IMG_1418ann
I had also been working on a stainless steel cover/mount which attaches to the lower firewall and will support the front edge of the monowheel hole cover.
Date: 12/20/2010
Views: 3415
|
|
|
IMG_1368
I ordered new registration numbers as the old numbers were not properly legal. They arrived and I put the starboard side on first.
Date: 05/18/2011
Views: 3067
|
|
|
IMG_0099post
Date: 09/03/2010
Views: 2838
|
|
|
IMG_0055post
Date: 09/01/2010
Views: 3524
|
|
|
IMG_1284ann
Cut a piece of aluminum for the console cover. Laid out the pattern on the aluminum sheet and traced around it.
Date: 03/30/2011
Views: 2996
|
|
|
IMG_1412ann
2010 12 20 It's difficult to work in the hanger during the cold of late November and all of December. I tended to stay home and work in the shop on the "Taz" the Little Toot Sport Biplane I'm building. On the occasional nice day like this I ma
Date: 12/20/2010
Views: 3523
|
|
|
IMG_0927ann
And fill/sand continues on the wing repair areas.
Date: 03/02/2011
Views: 2764
|
|
|
IMG_0082post
Date: 09/02/2010
Views: 2838
|
|
|
IMG_1595ann
Test fit of the intercooler.
Date: 03/16/2011
Views: 3274
|
|
|
IMG_0185post
Date: 09/07/2010
Views: 2789
|
|
|
IMG_0117post
Date: 09/03/2010
Views: 2767
|
|
|
IMG_3290post
Here you can see where the gasket was cut by the bowl where it wasn't properly located.
Date: 05/31/2012
Views: 3916
|
|
|
IMG_1262ann
2011 03 28 Propeller has been installed.
Date: 03/28/2011
Views: 3308
|
|
|
IMG_3265
Herein lies the culprit! The change from flat fiber washer to "O" ring. When the "O" ring is applied to the attachment screw and tightened to the torque spec, the bottom of the fuel bowl is deformed upward. This deformation reduces
Date: 05/30/2012
Views: 22284
|
|
|
IMG_0132post
Date: 09/03/2010
Views: 2827
|
|
|
IMG_1255ann
The superfluous pump and plumbing removed. In addition, I connected the flaps to the electrical power source for the main pump (not shown). This provides power to the flaps through the old pump circuit breaker path. Tested and it works fine.
Date: 03/25/2011
Views: 2964
|
|
|
IMG_0129post
Date: 09/03/2010
Views: 3308
|
|
|
IMG_0458ann
I've gone back to the build manual and made up a pair of reinforcements. Here marking where the upholstery will be cut to make a place for them.
Date: 10/20/2010
Views: 3180
|
|
|
New MC-4A 05
With the attach fitting fully screwed on to the end of the thread, the last bit of thread is just visible in the fitting.
Date: 04/12/2012
Views: 2897
|
|