|
IMG_0414
Date: 04/18/2015
Views: 11274
|
|
|
DSC00215
foam removed to make space for the rudder bracket
Date: 09/09/2015
Views: 10947
|
|
|
DSC00165
Trial fit of the push rod bracket! Doesn't look good. This is going to take some thought.
Date: 09/04/2015
Views: 15395
|
|
|
IMG_0823
Same of port side.
Date: 09/03/2015
Views: 8543
|
|
|
DSC00157
Instructions state that rod should be reamed to 0.375" but it needed to be reamed out 0.428" to fit push rod.
Date: 09/03/2015
Views: 10323
|
|
|
IMG_0390
Date: 04/10/2015
Views: 9326
|
|
|
Rivets
Next problem. Once the push rod end was fitted and drilled according to the manual the rivets provided were too short to go through the whole structure. Awaiting a response from Europa
Date: 09/03/2015
Views: 10303
|
|
|
IMG_0406
Date: 04/17/2015
Views: 9856
|
|
|
GoPro1 002
Garden before
Date: 03/17/2014
Views: 15202
|
|
|
IMG_0412
Date: 04/17/2015
Views: 10268
|
|
|
DSC00163
Rudder opened up to accept the push rod bracket. Alas no blue foam as it is the NG model. No instructions on how to proceed. Advice from Europa is to bod in some blue foam is it is not load bearing and is just a bed for the composite.
Date: 09/04/2015
Views: 12554
|
|
|
IMG_0237
Fuselage in the truck
Date: 02/01/2014
Views: 10775
|
|
|
DSC00149
Winch installed in garage
Date: 09/01/2015
Views: 11626
|
|
|
IMG_0344[1]
Aircraft parts & Documents stored
Date: 09/04/2014
Views: 10872
|
|
|
IMG_0190[1]
Date: 04/13/2014
Views: 12569
|
|
|
DSC00153
Lathe installed
Date: 09/01/2015
Views: 11735
|
|
|
DSC00160
Foam removed from rear bulk head ready for plywood inserts
Date: 09/03/2015
Views: 11833
|
|
|
IMG_0231
Date: 01/31/2014
Views: 10880
|
|
|
IMG_0410
Date: 04/17/2015
Views: 11659
|
|
|
IMG_0400
Date: 04/14/2015
Views: 10226
|
|