|
IMG_0340[1]
cloth cabinet installed.
Date: 09/04/2014
Views: 14269
|
|
|
IMG_0409
Date: 04/17/2015
Views: 8826
|
|
|
IMG_0414
Date: 04/18/2015
Views: 10491
|
|
|
IMG_0412
Date: 04/17/2015
Views: 9424
|
|
|
IMG_0191[1]
Date: 09/12/2015
Views: 9159
|
|
|
DSC00153
Lathe installed
Date: 09/01/2015
Views: 10733
|
|
|
IMG_0231
Date: 01/31/2014
Views: 10020
|
|
|
IMG_0392
Date: 04/10/2015
Views: 8549
|
|
|
IMG_0410
Date: 04/17/2015
Views: 10913
|
|
|
IMG_0417
Date: 04/22/2015
Views: 9446
|
|
|
IMG_0390
Date: 04/10/2015
Views: 8702
|
|
|
IMG_0406
Date: 04/17/2015
Views: 9094
|
|
|
Rivets
Next problem. Once the push rod end was fitted and drilled according to the manual the rivets provided were too short to go through the whole structure. Awaiting a response from Europa
Date: 09/03/2015
Views: 8753
|
|
|
Ipad 039
Concrete base for 20ft x 10ft shed
Date: 03/22/2014
Views: 8171
|
|
|
DSC00228
Had to remove more of the rudder than I wanted so build up rudder trailing edge by attaching peel ply to the outside of the rudder and build up trailing edge using flox around the edge and an initial 2 ply of bid. i'll apply an additional 2 ply after the
Date: 09/10/2015
Views: 8578
|
|
|
DSC00149
Winch installed in garage
Date: 09/01/2015
Views: 10676
|
|
|
DSC00219
bracket installed
Date: 09/09/2015
Views: 10518
|
|
|
IMG_0344[1]
Aircraft parts & Documents stored
Date: 09/04/2014
Views: 10130
|
|
|
DSC00157
Instructions state that rod should be reamed to 0.375" but it needed to be reamed out 0.428" to fit push rod.
Date: 09/03/2015
Views: 8836
|
|
|
IMG_0245
Wife not happy. Aircraft parts in the house!
Date: 02/01/2014
Views: 9727
|
|