|
DSC08799
Port side
Date: 06/05/2012
Views: 9647
|
|
|
dsc08627
The monowheel landing gear is in the up position and resting on the main wheel with some of the weight held by the block and tackle. This was taken just before putting on the braces to keep her from rolling. Been trying to get rid of that tv in the back
Date: 04/14/2012
Views: 10861
|
|
|
dsc08623
bungee cord removal.
Date: 04/14/2012
Views: 18247
|
|
|
dsc09033
Port side done.
Date: 01/22/2013
Views: 8225
|
|
|
20141102_152814
Drilling out the screw. It would move. I'm removing this plate to patch later.
Date: 11/02/2014
Views: 11282
|
|
|
dsc09046
Making a layup schedule for rib 1.
Date: 01/23/2013
Views: 8651
|
|
|
dsc09064
Bill does nice peel ply work!
Date: 01/24/2013
Views: 8500
|
|
|
dsc08608
These will have to go. They are on top and I will remove them and put one vent on the bottom.
Date: 04/10/2012
Views: 12337
|
|
|
nex_2013_08_24_03
nex_2013_08_24_03.jpg
Date: 08/25/2013
Views: 7142
|
|
|
nex_2014_01_25_28
Wings on. Not really required at the stage. Just had to do it for motivation.
Date: 01/26/2014
Views: 7833
|
|
|
dsc09021
BIG THANK YOU to my Uncle Kim Prout for flying out to help me with getting the gear legs set. He also helped me slow down and plan ahead. As an excited new builder its easy to get in a rush to try achieve something tangible. Im sure after that week of b
Date: 01/22/2013
Views: 8747
|
|
|
p1000471
p1000471.jpg
Date: 12/13/2011
Views: 11872
|
|
|
Orange part created in turbocad and printed on a 3D printer from ABS. Printer is a Prusa i3 X, cost is around $300.
Orange part created in turbocad and printed on a 3D printer from ABS. Printer is a Prusa i3 X, cost is around $300.
Date: 04/03/2016
Views: 19069
|
|
|
p1000702
p1000702.jpg
Date: 03/12/2012
Views: 5886
|
|
|
nex_2014_01_25_04
Bill helping hoist the aircraft up to remove the jig.
Date: 01/25/2014
Views: 7737
|
|
|
dsc08606
Old mass balance arm.
Date: 04/10/2012
Views: 9817
|
|
|
dsc08631
More of the same.
Date: 04/14/2012
Views: 7410
|
|
|
nex_2013_08_24_04
As you see here the port side is done with rib 3 and 4. I didn't have photos of doing the layups.
Date: 08/25/2013
Views: 7436
|
|
|
p1000690
p1000690.jpg
Date: 03/12/2012
Views: 6379
|
|
|
dsc09041
Port side guides being placed for layup.
Date: 01/23/2013
Views: 8790
|
|