|
p1000634
p1000634.jpg
Date: 02/14/2012
Views: 6953
|
|
|
p1000704
p1000704.jpg
Date: 03/12/2012
Views: 6199
|
|
|
DSC08800
starboard side
Date: 06/05/2012
Views: 10189
|
|
|
dsc08623
bungee cord removal.
Date: 04/14/2012
Views: 19076
|
|
|
dsc09035
Rib one after cure of 420 and peel ply removed. Think we used 112g of 420 here due to the odd angle.
Date: 01/23/2013
Views: 8337
|
|
|
p1000696
p1000696.jpg
Date: 03/12/2012
Views: 6639
|
|
|
dsc09066
Port side peel ply removed. Oh notice the caps in the sockets. What I did was take a block of foam and push it down in the socket, then took it back out and covered it with car wax. Once all the ribs are in I'll see how it worked.
Date: 01/25/2013
Views: 9137
|
|
|
p1000706
p1000706.jpg
Date: 03/12/2012
Views: 6145
|
|
|
nex_2014_01_12_02
Rat's tail rasp works great here.
Date: 01/13/2014
Views: 7724
|
|
|
p1000627
p1000627.jpg
Date: 02/14/2012
Views: 7602
|
|
|
20160403_160443.jpg
20160403_160443.jpg
Date: 04/03/2016
Views: 14120
|
|
|
dsc09019
Trash can is the best way to hold the landing gear legs.
Date: 01/10/2013
Views: 8944
|
|
|
dsc08661
Locating the center of the main gear hole. Used a pilot to be used to measure out the 10“ diameter on the bottom.
Date: 04/22/2012
Views: 12567
|
|
|
dsc08609
Underside of vents.
Date: 04/10/2012
Views: 13194
|
|
|
nex_2014_01_25_04
Bill helping hoist the aircraft up to remove the jig.
Date: 01/25/2014
Views: 8127
|
|
|
nex_2013_08_24_04
As you see here the port side is done with rib 3 and 4. I didn't have photos of doing the layups.
Date: 08/25/2013
Views: 7828
|
|
|
dsc08629
In a few mins she will no longer be a monowheel :-(
Date: 04/14/2012
Views: 8827
|
|
|
dsc09038
To make our backs happy and life 1000% easier we tilted the fuselage. Notice I used my monowheel trailer as a jig. A tow strap 4" wide was used in the rear to hold the tail. This was rock solid.
Date: 01/23/2013
Views: 9534
|
|
|
p1000631
p1000631.jpg
Date: 02/14/2012
Views: 7323
|
|
|
photo
No pictures of the progress of putting in the LG layups on the port side. Here I am putting down the peel ply.
Date: 08/20/2012
Views: 15619
|
|