|
IMG_9572post
Made sure that the vent line was attached and run to the back and down into the area below the engine, but not into the air stream.
Date: 06/12/2010
Views: 3646
|
|
|
IMG_1093ann
Finally, problem #3 - 3/8" hose barb input and 1/4" hose barb output. There is an issue locating a 1/4" hose barb banjo to attach to the Rotax fuel pressure regulator.
Date: 04/03/2010
Views: 3748
|
|
|
Calliper 2
The best solution is shown in this pic from Mike Parkin. A Banjo fitting. The Banjo bolt is straight threads, it lies low, out of the way of grabby things and is stoutly attached. So, I have a number of bits on order from various suppliers in an attem
Date: 06/23/2009
Views: 3231
|
|
|
DSCN6155Ann
Date: 06/18/2007
Views: 3469
|
|
|
IMG_6966post
Port side juncture of main beam with cross beam.
Date: 12/27/2009
Views: 3211
|
|
|
DSCN6125Ann
Date: 06/14/2007
Views: 3125
|
|
|
Plexi02small
Date: 04/04/2005
Views: 5299
|
|
|
IMG_6707Ann
Date: 02/15/2008
Views: 4161
|
|
|
2_Door_Knobs
They work well without any protruding or scratch making lumps or bumps.
Date: 06/23/2011
Views: 3773
|
|
|
Upholstery
Date: 04/19/2006
Views: 4754
|
|
|
LongRangeTankBoM
Date: 07/31/2004
Views: 4200
|
|
|
IMG_7530ann
First try was just to bolt the BSPP banjo onto the brake. Needless to say, that was just too simple to work. It wouldn't seat properly in the BSPT brake.
Date: 04/18/2010
Views: 3159
|
|
|
DSC04012_Large_post
Date: 10/19/2009
Views: 3995
|
|
|
IMG_6792post
Width and thickness of the tail wheel "U" channel
Date: 12/10/2009
Views: 3264
|
|
|
IMG_0037
More retraction tests. Closer, but still won't quite go into up lock. Maybe 1/4" (0.635 cm) from engaging. Back under for a couple more hours before I finally see where the blue from the fitting is rubbing on the side of the tunnel where the seat
Date: 07/07/2010
Views: 3276
|
|
|
IMG_1235ann
2010 06 21 - The new Billet pump and regulator arrived so I went out to the hanger and installed it. The new pump and regulator were supplied with AN6 Flared Tube fittings this time so the exchange was trivial. Must have taken all of 5 minutes.
Date: 06/21/2010
Views: 3911
|
|
|
P4141325
Date: 04/16/2006
Views: 3762
|
|
|
DSCN6124Ann
Date: 06/14/2007
Views: 3027
|
|
|
IMG_1217ann
Date: 06/13/2010
Views: 3218
|
|
|
OregonAero00small
Date: 07/19/2005
Views: 3118
|
|