|
IMG_9557ann
I dug out a bunch, and came to the conclusion that I'm going to have to order a new brake line and clean out the master cylinder before I can continue here. So I went on to the new mechanical fuel pump installation...
Date: 06/06/2010
Views: 3109
|
|
|
MDO_Aircraft_P1
Date: 10/18/2009
Views: 6642
|
|
|
DSCN6128Ann
Date: 06/14/2007
Views: 3482
|
|
|
5_snaps
The new snap bases installed in the head rest.
Date: 06/23/2011
Views: 4508
|
|
|
Seat_Back
Date: 04/19/2006
Views: 4406
|
|
|
DSCN6166An
Date: 06/24/2007
Views: 3018
|
|
|
IMG_6679Ann
Date: 02/15/2008
Views: 4925
|
|
|
Intercooler08
Date: 01/07/2006
Views: 4137
|
|
|
IMG_7440post
2010 03 19 - Checked to see if the new brake banjo hardware would work while completing the Annual Condition Inspection on the Europa. This is a comparison of the original fitting from the brake with the new banjo bolt that's supposed to work. Close, bu
Date: 03/19/2010
Views: 3352
|
|
|
IMG_7268post
Date: 02/21/2010
Views: 3992
|
|
|
2ndAlternator03small
Date: 04/04/2005
Views: 3976
|
|
|
1_Door_Knobs
The new door knob mounting hardware is a stainless steel "binding post" acquired from McMaster-Carr. These things are available in myriad materials and sizes. There just happened to be a perfect size in the stainless steel variety which I pref
Date: 06/23/2011
Views: 4540
|
|
|
IMG_9570ann
2010 06 12 - Completed the plumbing for the new mechanical fuel pump this morning. Fire shield on all fuel lines. Everything connected in the proper sequence.
Date: 06/12/2010
Views: 3586
|
|
|
IMG_7529ann
The new BSPP (British Standard Pipe Parallel) banjo bolts finally arrived from Speed Flow of Australia last week. Due to a death in the family and illnesses, I haven't gotten back to working on the Europa for several weeks. But I did today. I had also
Date: 04/18/2010
Views: 3127
|
|
|
IMG_9536ann
Date: 06/03/2010
Views: 3231
|
|
|
IMG_6976post
Length of ramp up to trimmed corner
Date: 12/27/2009
Views: 3456
|
|
|
IMG_6684Ann
Date: 02/15/2008
Views: 3870
|
|
|
IMG_9572post
Made sure that the vent line was attached and run to the back and down into the area below the engine, but not into the air stream.
Date: 06/12/2010
Views: 3794
|
|
|
IMG_6695Ann
Date: 02/15/2008
Views: 4112
|
|
|
IMG_1086ann
Back in early April I attempted to bolt the new Billet Pump onto the gearbox. Problem #1 - It didn't fit the boss on the gearbox. It hit a raised area at the edge of the boss.
Date: 04/03/2010
Views: 3608
|
|