|
|
IMGA0712
Made some stands and a reference plate which is at 90 degrees to the spar
Date: 04/23/2013
Views: 101199
|
|
|
IMGA0728
Date: 07/14/2015
Views: 100064
|
|
|
|
IMGA0893
Date: 09/21/2016
Views: 99946
|
|
|
IMGA0813
Date: 06/24/2016
Views: 99833
|
|
|
|
IMGA0664
Scrap bit of foam which will get sanded to match the profile of the block. It takes up the gap between spar and end of the block
Date: 04/17/2013
Views: 99107
|
|
|
IMGA0707
The next day me and my helper Ang did the other wing. This time it only took 6 and half hours so left us time to trim the other wing
Date: 04/21/2013
Views: 98810
|
|
|
|
IMGA0716
Date: 07/13/2015
Views: 97317
|
|
|
IMGA0811
Flap closeout
Date: 05/14/2013
Views: 97252
|
|
|
|
IMGA0716
Cracked off the jig, flipped over, and there we go iv got half a wing!!
Date: 04/23/2013
Views: 97108
|
|
|
IMGA0810
Date: 06/20/2016
Views: 95115
|
|
|
|
IMGA0820
Aileron closeout
Date: 05/15/2013
Views: 93682
|
|
|
IMGA0609
Date: 06/28/2014
Views: 93675
|
|
|
|
IMGA0585
Date: 03/18/2013
Views: 92273
|
|
|
IMGA0605
Date: 06/25/2014
Views: 91511
|
|
|
|
IMGA0722
Just testing out the rear blocks for an idea what it will look like
Date: 04/24/2013
Views: 91276
|
|
|
IMGA0573
Date: 03/17/2013
Views: 89947
|
|
|
|
IMGA0750
Made a tube of bid to carry the pitot tubes from one block to another. This block is where the bell crank sits and the push rod goes to the aileron.
Date: 05/05/2013
Views: 89755
|
|
|
IMGA0756
Some dry micro to stick the block to the spar
Date: 05/05/2013
Views: 89739
|
|
|
|
IMGA0833
Remove trailing edge support ready for skin lay up
Date: 05/17/2013
Views: 89584
|
|
|
IMGA0572
Date: 03/17/2013
Views: 88833
|
|
