Fletner_8

Here you see foam dig out filled with flox.
Using Aeropoxy with 30 minute hardener, wet out strips both sides and antiservo tab. Then waited till it began to kick and applied some Q-cel to bonding side of strip and positioned this thick mixture.
Then tried clamping with paper clips that were prepared with 3M 375 packaging tape applied to contact area.
The strips slid aft.
Quick thinking put 3M 375 tape up and over and clipped over the tape. Worked great as long as no Aeropoxy gets between tape and clip. If it does clip will slip forward, easy fix, put on another piece of tape and clean clip.
Y9-06-02