Front Starboard fuse stiffening for lift socket 3.
Date: 10/24/2010
Views: 2955
Door hinge rebates 24.
Date: 11/03/2009
Views: 2410
PitotStaticII17
Date: 06/04/2003
Views: 4553
Newest Image
EAA SITE
Date: 08/23/2023
Views: 118346
Most Viewed Image
Wing fillet fairing
Date: 05/23/2007
Views: 542125
Lengthening snap bushing 1.
Dug out a little foam in 5/16" hole, then cut two snap bushings where they fit together by removing 1/2 of a side. This leaves a nice rounded entry and exit. I didn't want to make a huge hole for rubber grommet. Wires going to reed switches will be 2 conductor shielded. Reason for shielding is for robustness. Snap bushings were floxed in place. By leaving 1/2 remaining on each side, there was 1 snap that will get nice and stuck once flox cures.
Y10-06-13