|
|
Cut down 1" aft threaded rod to .700"
Date: 12/13/2013
Views: 7737
|
|
|
1/2" ball end-mill on order (McMaster) to to mill a pocket in the brake master cylinder directly above the mounting holes
Date: 12/13/2013
Views: 8498
|
|
|
|
Temporary mount using 1 flat head 1/4-28
Date: 12/13/2013
Views: 7528
|
|
|
Cable Happy near Fuel Selector and below Air-Brake Cable 2
Date: 12/12/2013
Views: 7753
|
|
|
|
Supplied with cable nuts were .190" thick
Date: 12/13/2013
Views: 8129
|
|
|
FLAP PUSH-PULL CABLE: JUST "MAKE IT WORK"
Date: 12/05/2013
Views: 13517
|
|
|
|
I failed a bearing on purpose
Date: 11/27/2013
Views: 14884
|
|
|
Cut down Heims to 1.700"
Date: 12/13/2013
Views: 6760
|
|
|
|
Emergency Maneuver that starts with Heim? 9 of 13
Date: 12/16/2013
Views: 8034
|
|
|
Emergency Maneuver that starts with Heim? 7 of 13
Date: 12/16/2013
Views: 8062
|
|
|
|
Overall view of front mount
Date: 12/13/2013
Views: 7211
|
|
|
Mill round slot in master cylinder 1 of 2
Date: 12/23/2013
Views: 7599
|
|
|
|
Length of coupler is ~ .855" cut down from 1". 9.5 times two is 19, so this allows minimum of 19 threads of engagement
Date: 12/13/2013
Views: 6577
|
|
|
Series 6 Push-Pull cable Weight and Length
Date: 12/16/2013
Views: 9582
|
|
|
|
Emergency Maneuver that starts with Heim? 2 of 13
Date: 12/16/2013
Views: 9092
|
|
|
Prior to work Y13-12-15 (compare to prior pic)
Date: 12/13/2013
Views: 7834
|
|
|
|
1/2" clamps that allow cable to slide 2 of 2
Date: 12/16/2013
Views: 10228
|
|
|
Pretty much the front is flight ready.
Date: 12/16/2013
Views: 10197
|
|
|
|
Front Cable Mount with Lever in Up Position
Date: 12/12/2013
Views: 7905
|
|
|
Clevis Fork dimensions after material removal
Date: 12/16/2013
Views: 8170
|
|
