DSC00153

Lathe installed

DSC00149

Winch installed in garage

IMG_0344[1]

Aircraft parts & Documents stored

IMG_0340[1]

cloth cabinet installed.

IMG_0187[1]

Started to fit fixtures and fittings

IMG_0189[1]

IMG_0190[1]

IMG_0191[1]

DSC00229

Still some work to do but happy so far.

DSC00228

Had to remove more of the rudder than I wanted so build up rudder trailing edge by attaching peel ply to the outside of the rudder and build up trailing edge using flox around the edge and an initial 2 ply of bid. i'll apply an additional 2 ply after the

DSC00219

bracket installed

DSC00214

blue foam placed in rudder to fill void

DSC00215

foam removed to make space for the rudder bracket

DSC00212

Marking position for bracket on rear bulk head

IMG_0823

Same of port side.

Torque tube

Took some measurements and sent query to Europa. Response was I required the issue 1 TP38s

DSC00155

As you can see the Issue 1 Bearings are considerably longer and will require shortening once I have the correct dimensions.

IMG_0821

Trial fitted the torque tube but it looks like the TP38 bearing is too short!

DSC00165

Trial fit of the push rod bracket! Doesn't look good. This is going to take some thought.

DSC00157

Instructions state that rod should be reamed to 0.375" but it needed to be reamed out 0.428" to fit push rod.