|
|
DSC00158
Date: 09/03/2015
Views: 117845
|
|
|
DSC00165
Trial fit of the push rod bracket! Doesn't look good. This is going to take some thought.
Date: 09/04/2015
Views: 105076
|
|
|
|
DSC00212
Marking position for bracket on rear bulk head
Date: 09/08/2015
Views: 103151
|
|
|
DSC00229
Still some work to do but happy so far.
Date: 09/10/2015
Views: 102588
|
|
|
|
DSC00160
Foam removed from rear bulk head ready for plywood inserts
Date: 09/03/2015
Views: 101445
|
|
|
DSC00214
blue foam placed in rudder to fill void
Date: 09/08/2015
Views: 100102
|
|
|
|
DSC00219
bracket installed
Date: 09/09/2015
Views: 95204
|
|
|
DSC00163
Rudder opened up to accept the push rod bracket. Alas no blue foam as it is the NG model. No instructions on how to proceed. Advice from Europa is to bod in some blue foam is it is not load bearing and is just a bed for the composite.
Date: 09/04/2015
Views: 93556
|
|
|
|
DSC00215
foam removed to make space for the rudder bracket
Date: 09/09/2015
Views: 82008
|
|
|
DSC00157
Instructions state that rod should be reamed to 0.375" but it needed to be reamed out 0.428" to fit push rod.
Date: 09/03/2015
Views: 73048
|
|
|
|
DSC00228
Had to remove more of the rudder than I wanted so build up rudder trailing edge by attaching peel ply to the outside of the rudder and build up trailing edge using flox around the edge and an initial 2 ply of bid. i'll apply an additional 2 ply after the
Date: 09/10/2015
Views: 71391
|
|
|
Rivets
Next problem. Once the push rod end was fitted and drilled according to the manual the rivets provided were too short to go through the whole structure. Awaiting a response from Europa
Date: 09/03/2015
Views: 35323
|
|
