Orange part created in turbocad and printed on a 3D printer from ABS. Printer is a Prusa i3 X, cost is around $300.
Date: 04/03/2016
Views: 18091
Ceiling panel layout begins
Date: 03/05/2009
Views: 3363
IMG_0059
Date: 05/03/2007
Views: 3641
Newest Image
EAA SITE
Date: 08/23/2023
Views: 150668
Most Viewed Image
Wing fillet fairing
Date: 05/23/2007
Views: 554529
LL3
The 4509Q is not a Taxi light. I am certain a 100 watt GE taxi light is impressive, but at 100 watts and lots of heat and large size, this Kuntzleman as shown in pic is an acceptable taxi LED for our needs. Note height off ground is as if mounted on front of OR1.
Y9-01-15