Avelec fuel sender with 2 x 3 hole between headrests
Date: 09/07/2010
Views: 2141
20040209204608_G
Date: 12/31/1969
Views: 2666
Newest Image
EAA SITE
Date: 08/23/2023
Views: 143687
Most Viewed Image
Wing fillet fairing
Date: 05/23/2007
Views: 549476
IM003688
If Factory location does not work well for AOA, will just make hole in this wing cover and 2 BID back of cover with probe washer at proper angle, (2 BID should be weak enough to break in case of trauma instead of wing or cover?), TIG 2 stainless studs, (cut off head of screw), to probe washer and screw onto BID with nuts and washers, then fill probe washer with Redux/Q-Cel so as to be flush with cover and removable. Not done yet though, once clamp is removed will fill with area with Aeropoxy Light and level so will be ready for paint, (probably fill/sand twice, rare one pass does it).
Y7-12-02