Panel is warped on right side, will try some heat.
Date: 01/11/2010
Views: 3353
Newest Image
EAA SITE
Date: 08/23/2023
Views: 85661
Port wing 4.
Goiter removal, (seen on prior pict).
Aeropoxy light was applied heavier than you could believe which netted just about right.
Began sanding with 80 grit to about 1/16" thick, then went down to 120 grit, feathered in with 180/320 grit.
It needs an application or two of 3M flowable finishing putty to fill pinholes, voids and deeper sanding marks.
Very pleased with this first pass.
Y9-09-15