|
IMG_5905post
Date: 08/09/2009
Views: 2921
|
|
|
Time to start taper sanding 2.
Date: 11/01/2009
Views: 2486
|
|
|
05072003121948_G
Date: 12/31/1969
Views: 2511
|
|
|
DSCN6133
Date: 10/11/2009
Views: 4073
|
|
|
A061402_Goint_to_Paine4
Date: 12/31/1969
Views: 2836
|
|
|
Oil_Pan_input
I put two 1.25 inch holes on either side of the shark's tooth. They empty into a rectangular plenum about 4 X 2.5 that is terminated about 1/4 inch in front of the oil pan. The pan has cooling strips and the outside air contributes to oil cooling.
Date: 08/31/2011
Views: 16532
|
|
|
HEAVY MAINTENANCE ROTAX 914
Date: 08/08/2010
Views: 2168
|
|
|
DSCN4711Ann
Date: 09/03/2006
Views: 2823
|
|
|
DoorSupportMod39Ann
Date: 02/05/2006
Views: 3275
|
|
|
Control_Systems_50
Date: 01/23/2006
Views: 4152
|
|
|
Photo0017
Date: 10/12/2009
Views: 5171
|
|
|
DSC02149_Texted
Date: 12/31/1969
Views: 2641
|
|
|
EIS_Replaced02Ann
Date: 07/16/2005
Views: 2523
|
|
|
DSCF0110
Date: 06/22/2009
Views: 2994
|
|
|
IMG_2692
The longest AN3-30 bolt I had was too short so a longer bolt is on order as are aluminum spacers to maintain proper alignment of the ends of the MCs.
Date: 04/09/2012
Views: 3052
|
|
|
Wings on 1
Tommy and Russ stopped by to help me put the wings back on.
Date: 07/01/2011
Views: 3130
|
|
|
panel3
Date: 12/31/1969
Views: 5861
|
|
|
WEC_Trigear2
Date: 09/12/2004
Views: 4826
|
|
|
1_24_06_16
Date: 11/29/1999
Views: 3633
|
|
|
DSCN6507
Date: 10/25/2009
Views: 2325
|
|