|
070602_Aaron
Date: 12/31/1969
Views: 2829
|
|
|
Mod73_06
Date: 11/29/1999
Views: 3744
|
|
|
Rotax setup for certified 914s.
Date: 03/06/2007
Views: 6385
|
|
|
IMG_0034post
Date: 09/01/2010
Views: 3521
|
|
|
DSCN5445
Date: 07/21/2009
Views: 3017
|
|
|
DSCF0110
Date: 06/22/2009
Views: 2936
|
|
|
Front View Free End
Date: 03/31/2010
Views: 3490
|
|
|
Ruderr_5
Date: 05/23/2009
Views: 3494
|
|
|
IMG_8004Ann
Date: 07/02/2008
Views: 4360
|
|
|
DSCF0023
Date: 10/24/2010
Views: 2710
|
|
|
Mill round slot in master cylinder 2 of 12
Date: 12/23/2013
Views: 4216
|
|
|
IMG_1111
Date: 03/18/2004
Views: 3749
|
|
|
122_2234_IMG
Date: 01/28/2005
Views: 2992
|
|
|
Duxford_17_8_09_158
Date: 08/23/2009
Views: 2618
|
|
|
DSCN4378
Date: 03/26/2009
Views: 3060
|
|
|
dscn1581
Date: 12/31/1969
Views: 2851
|
|
|
dsc08642
From the start the airframe was sitting 2.5 deg tail low and 0.1 deg to port. Not bad for just putting her on there. I jacked up the back of the trailer to get it as near to 0.0 as possible and also shifted the airframe latterly to turn that .1 to 0.0 a
Date: 04/15/2012
Views: 10158
|
|
|
MG_2975
Date: 03/17/2008
Views: 2680
|
|
|
IM003647
Date: 11/25/2007
Views: 3471
|
|
|
TailWheelMount18
Date: 02/11/2004
Views: 2782
|
|