|
|
Supplied nuts are too thick for the thin side of the tang 2.
Date: 10/14/2009
Views: 4993
|
|
|
Bild_006
Date: 10/31/2008
Views: 7864
|
|
|
|
FletnerStripPort
Date: 06/10/2003
Views: 5535
|
|
|
DSCN5984Ann
Date: 05/04/2007
Views: 4320
|
|
|
|
IMG_3218
Once the brakes seemed to be OK it was time to run the engine and check it out. That didn't go well. Started well, warmed up with a bit of choke at the beginning. Smoothed out nicely and idled properly after it was all warmed up. Then I added throttle
Date: 05/18/2012
Views: 7052
|
|
|
dscn0412
Date: 12/31/1969
Views: 5357
|
|
|
|
DSCN6125Ann
Date: 06/14/2007
Views: 4682
|
|
|
Bb4
Date: 02/01/2009
Views: 5677
|
|
|
|
Aluminum Plenum flanges installed
Aluminum flanges were added to the plenums so that the plenums would not need to be fastened directly to the hot heads. Later in the build, the pop rivets were replaced with machine screws so that the front 2/3 of the plenum could be easily removed
Date: 01/01/2011
Views: 184227
|
|
|
CH29_23
Date: 08/06/2005
Views: 5779
|
|
|
|
CH22_9
Date: 12/31/1969
Views: 4916
|
|
|
IMG_7677.jpg
Date: 08/05/2012
Views: 18783
|
|
|
|
2005oct08_15
Date: 11/29/1999
Views: 6840
|
|
|
IMG_0361Ann
Date: 07/15/2008
Views: 5695
|
|
|
|
IMG_7764Ann
Date: 06/14/2008
Views: 4643
|
|
|
dscn0902
Date: 12/31/1969
Views: 4470
|
|
|
|
IMG_8842post
Date: 08/10/2009
Views: 6601
|
|
|
DSCN8318
Date: 09/18/2010
Views: 7327
|
|
|
|
083102_shop
Date: 12/31/1969
Views: 4542
|
|
|
Ardmore05
Date: 12/03/2004
Views: 5404
|
|
