|
|
051202_TPchkup
Date: 12/31/1969
Views: 4035
|
|
|
CH9_3
Date: 12/31/1969
Views: 35661
|
|
|
|
img0920copy
Date: 07/29/2007
Views: 5126
|
|
|
CBM - 25 - ELECTRICAL SYSTEM
Date: 11/18/2013
Views: 4288
|
|
|
|
010325_030
Date: 12/31/1969
Views: 4017
|
|
|
Fuel_System_33
Date: 09/16/2007
Views: 4957
|
|
|
|
IMG_6527Ann
Date: 01/06/2008
Views: 5428
|
|
|
E1
[quote="Bud Yerly"]"Make a glass cover that fits the hole out of three sheets of bid laid up on a flat surface. After cure, hold it up to the bottom of the plane and mark the contour. Cut and approximate the fit. It should be near level
Date: 10/05/2012
Views: 21601
|
|
|
|
IMG_0120
Date: 04/14/2005
Views: 6442
|
|
|
DSCN6325
Date: 10/11/2009
Views: 4593
|
|
|
|
DSCF0036
Date: 06/19/2009
Views: 4851
|
|
|
IMG_0047post
Walked down to the corner of the hanger to the next line of hangers where there is a WC. This is what I saw to the Southeast. Not looking good. Went to the WC and cleaned up. Looked even more threatening after the wash. Decided to close up and go hom
Date: 07/08/2010
Views: 4311
|
|
|
|
DSCN4670Ann
Date: 08/27/2006
Views: 4678
|
|
|
Orange part created in turbocad and printed on a 3D printer from ABS. Printer is a Prusa i3 X, cost is around $300.
Orange part created in turbocad and printed on a 3D printer from ABS. Printer is a Prusa i3 X, cost is around $300.
Date: 04/03/2016
Views: 28867
|
|
|
|
Bud 3
Date: 01/06/2010
Views: 6439
|
|
|
DSCN5215
Date: 11/29/1999
Views: 4581
|
|
|
|
CH9S_10
Date: 12/31/1969
Views: 12705
|
|
|
IMG_0003
Date: 04/10/2007
Views: 5931
|
|
|
|
IM003678
Date: 12/02/2007
Views: 6313
|
|
|
IMG_1235ann
2010 06 21 - The new Billet pump and regulator arrived so I went out to the hanger and installed it. The new pump and regulator were supplied with AN6 Flared Tube fittings this time so the exchange was trivial. Must have taken all of 5 minutes.
Date: 06/21/2010
Views: 5969
|
|
