|
Baggage_Area_26
Date: 06/03/2007
Views: 2596
|
|
|
031302_panellayup2
Date: 12/31/1969
Views: 2659
|
|
|
IMG_7541ann
It took almost an hour to carefully and safely get the tap started in the aluminum brake. I sure didn't want to screw that up. Once I had a good start and the tap began to cut, I clamped the tap in the vice with the brake held high so chips fall out and
Date: 04/18/2010
Views: 2643
|
|
|
120502_GCdoor_1
Date: 12/31/1969
Views: 2885
|
|
|
DSCN6250
Date: 10/11/2009
Views: 2821
|
|
|
Oil_Pan_input
I put two 1.25 inch holes on either side of the shark's tooth. They empty into a rectangular plenum about 4 X 2.5 that is terminated about 1/4 inch in front of the oil pan. The pan has cooling strips and the outside air contributes to oil cooling.
Date: 08/31/2011
Views: 15977
|
|
|
SA006a_Page_1
Date: 03/24/2009
Views: 3185
|
|
|
DSCF0012
Date: 02/04/2009
Views: 2975
|
|
|
Panel_1_Layout
Date: 09/02/2004
Views: 3487
|
|
|
IMG_6605Ann
Date: 01/20/2008
Views: 5070
|
|
|
Front fuse conduit run 15.
Date: 09/09/2010
Views: 3091
|
|
|
6_Dam_balsa_removed
Date: 10/29/2007
Views: 3202
|
|
|
109_0973_IMG
Date: 01/28/2004
Views: 4109
|
|
|
IMG_3274
Date: 11/18/2016
Views: 8199
|
|
|
DSCN6594
Date: 10/25/2009
Views: 2154
|
|
|
IMG_0975Ann
Date: 08/06/2007
Views: 3934
|
|
|
DSCN8346
Date: 09/19/2010
Views: 2895
|
|
|
IMG_8203Ann
Date: 07/18/2008
Views: 2447
|
|
|
IMG_2328
Date: 07/10/2005
Views: 3419
|
|
|
Teflon & Steel Pin Hinge_ LAA Mod_
Date: 08/19/2010
Views: 2067
|
|