|
|
IMG_0845
Date: 11/17/2005
Views: 6292
|
|
|
IMG_0138post
Date: 09/03/2010
Views: 4316
|
|
|
|
Flap drive pin install 15.
Date: 12/07/2010
Views: 7664
|
|
|
GJ7I2451
Date: 07/09/2006
Views: 4955
|
|
|
|
3_snaps
The original snap base hardware is on the right. The new snap bases and mounting hardware are on the left. These 6-32 screw mount snap bases are from McMaster-Carr. I used big ol' AN970 washers for more support underneath and nyloc nuts so they don't c
Date: 06/23/2011
Views: 7135
|
|
|
DSCF0015
Date: 01/26/2009
Views: 6686
|
|
|
|
Making awful fit of lift pads correct 6.
Date: 10/12/2010
Views: 7691
|
|
|
IMG_6901small
Date: 03/06/2008
Views: 4751
|
|
|
|
DSCN8311
Date: 09/18/2010
Views: 6623
|
|
|
DSCN6366
Date: 10/11/2009
Views: 5631
|
|
|
|
IMG_2869Ann
Date: 12/13/2008
Views: 5139
|
|
|
Mystery 1.
Date: 04/15/2009
Views: 7964
|
|
|
|
IMG_2187Ann
Date: 09/19/2008
Views: 5331
|
|
|
Wayne has warning PCB about 4/4 complete 3.
Date: 10/05/2010
Views: 7915
|
|
|
|
Setup_for_Project_Visit_2
Date: 12/31/1999
Views: 5534
|
|
|
IMGA0664
Scrap bit of foam which will get sanded to match the profile of the block. It takes up the gap between spar and end of the block
Date: 04/17/2013
Views: 99005
|
|
|
|
Fuselage_08
Date: 01/23/2006
Views: 5916
|
|
|
dsc09022
Here you see I used bondo on the shims and screwed them down into the block. The shims made sure the guide was level. Also note the hole drilled in the Aluminum angle and the shim. This is where I fixed the guide for the curing stage to ensure nothing
Date: 01/22/2013
Views: 21466
|
|
|
|
IMG_1477p
started on the nose wheel and strut. Made brackets for the wheel pant.
Date: 06/08/2011
Views: 4828
|
|
|
15042008039_G
Date: 10/07/2009
Views: 7070
|
|
