|
DSCN5440
Date: 07/20/2009
Views: 2844
|
|
|
IMG_0308
Date: 04/17/2005
Views: 2818
|
|
|
Fin cap install 1.
Date: 05/07/2009
Views: 3361
|
|
|
Eric Engineering torque wrench extension
Date: 12/03/2013
Views: 3804
|
|
|
IMG_7384ann
The threads on both fittings are 24/in. So that's a match. The issue is one is straight and the other pipe thread.
Date: 03/07/2010
Views: 2785
|
|
|
IMG_3375
Date: 10/24/2010
Views: 3198
|
|
|
DSCN5951Ann
Date: 04/26/2007
Views: 2534
|
|
|
IMG_0821
Trial fitted the torque tube but it looks like the TP38 bearing is too short!
Date: 09/03/2015
Views: 6840
|
|
|
DSCN6264
Date: 10/11/2009
Views: 2577
|
|
|
IM002769
Date: 10/30/2007
Views: 4213
|
|
|
DSCF0007
Date: 03/02/2009
Views: 2800
|
|
|
IMG_1412
Another issue with the pre-built cockpit module. The fuel tank was not supported on the aluminum angle. Bud suggested this could cause tank cracking and recommended some sort of support be added. I cut a wedge from a length of balsa and covered it with
Date: 05/28/2011
Views: 2730
|
|
|
p1000730
p1000730.jpg
Date: 03/12/2012
Views: 5624
|
|
|
dscn0316
Date: 12/31/1969
Views: 2390
|
|
|
dscn0816
Date: 12/31/1969
Views: 2181
|
|
|
DSCF0715
Date: 08/02/2003
Views: 3316
|
|
|
first_flight_5
Date: 07/19/2007
Views: 2514
|
|
|
nex_2014_01_25_02
Starboard side of the air bubble fix on rib one. Used Flox with aeroboxy as a fillit.
Date: 01/25/2014
Views: 6238
|
|
|
DSCF0097
Date: 06/22/2009
Views: 2964
|
|
|
DoorSupportMod07Ann
Date: 05/05/2004
Views: 1988
|
|