|
|
DSC00228
Had to remove more of the rudder than I wanted so build up rudder trailing edge by attaching peel ply to the outside of the rudder and build up trailing edge using flox around the edge and an initial 2 ply of bid. i'll apply an additional 2 ply after the
Date: 09/10/2015
Views: 66967
|
|
|
109_0913_IMG
Date: 01/06/2004
Views: 6560
|
|
|
|
Flap Mark Down
Flap down. Just about perfect. And I can even see them from the cockpit.
Date: 07/01/2011
Views: 4175
|
|
|
DSCN5721
Date: 11/29/1999
Views: 4650
|
|
|
|
DSCN6460
Date: 10/25/2009
Views: 5661
|
|
|
Fuel_System_5
Date: 04/15/2006
Views: 4364
|
|
|
|
WingSetC01Ann
Date: 08/07/2004
Views: 3648
|
|
|
GJ7I2464
Date: 07/09/2006
Views: 5439
|
|
|
|
DSCF0040
Date: 08/18/2009
Views: 4351
|
|
|
Fin cap install 1.
Date: 05/07/2009
Views: 7500
|
|
|
|
dsc09072
Here is a shot of the working angle. This was so much better than leaning over the edge. Kim's idea. Notice the heater behind Kim, this was key to keeping the temps even though the temps outside were in the 40's.
Date: 01/26/2013
Views: 19517
|
|
|
New MC-4A 06
Now the aft ends of the MC-4A's will be within the limits while the brake levers are properly positioned for operation and fit.
Date: 04/12/2012
Views: 4196
|
|
|
|
Port_wing_radius_Y9_06_07
Date: 06/07/2009
Views: 4546
|
|
|
Wiring30Ann
Date: 12/09/2005
Views: 4210
|
|
|
|
DSCN6058
Date: 10/11/2009
Views: 5779
|
|
|
IMG_0898
Date: 11/22/2005
Views: 5320
|
|
|
|
IMG_0151
Date: 04/14/2005
Views: 4150
|
|
|
DSCF0048
Date: 07/15/2009
Views: 5033
|
|
|
|
Fin rib conduit 2.
Date: 04/14/2009
Views: 6959
|
|
|
IMG_5746Ann
Date: 10/26/2007
Views: 4499
|
|
