|
|
N4211W wing rigging 14.
Date: 10/09/2010
Views: 6997
|
|
|
IMG_6976
At this point all that's left is that portion of the tank which was bonded to the back of the back rest.
Date: 10/19/2013
Views: 9743
|
|
|
|
A031203wingstand2
Date: 12/31/1969
Views: 4359
|
|
|
IMG_1739
Date: 07/12/2004
Views: 6934
|
|
|
|
TrimRelayDeck06Ann
Date: 09/27/2004
Views: 6445
|
|
|
HomemadeRotax 9XX gearbox puller
Date: 07/22/2010
Views: 5835
|
|
|
|
OutsideOpen
Date: 12/31/1969
Views: 6112
|
|
|
Gap fill 8.
Date: 10/29/2009
Views: 5240
|
|
|
|
IMG_0306post
Date: 09/18/2010
Views: 9311
|
|
|
011902_outrigger_down
Date: 12/31/1969
Views: 4059
|
|
|
|
DSCN3942
Date: 09/30/2005
Views: 4572
|
|
|
Upper aft pin to striker angles.
Date: 01/08/2010
Views: 6267
|
|
|
|
xs_mw_owners_manual
Date: 11/18/2013
Views: 5889
|
|
|
11022008002_G
Date: 09/13/2009
Views: 7806
|
|
|
|
Tie-bar 23.
Date: 11/14/2010
Views: 6299
|
|
|
3_snaps
Went to good old McMaster-Carr and, sure enough, they had multiple options for screw-down snap bases. Ordered these nice stainless steel snap bases with integral 6-32 screw. Used AN970 washers and nylock nuts to hold them on. Nyloc because when I remov
Date: 06/23/2011
Views: 4728
|
|
|
|
Second pass 1
Date: 08/03/2013
Views: 7978
|
|
|
IMG_6960
The rotary tool that did most of the cutting. Front and rear sides of the back rest.
Date: 10/17/2013
Views: 10033
|
|
|
|
IMG_6788small
Date: 02/23/2008
Views: 5584
|
|
|
DSCN6334
Date: 10/11/2009
Views: 5320
|
|
