|
|
CH5_3
Date: 12/31/1969
Views: 6706
|
|
|
110_1040_IMG
Date: 03/02/2004
Views: 13077
|
|
|
|
DSCN5945Ann
Date: 04/26/2007
Views: 5528
|
|
|
IMGA0712
Made some stands and a reference plate which is at 90 degrees to the spar
Date: 04/23/2013
Views: 100599
|
|
|
|
Middle fin rib complete 2.
Date: 04/27/2009
Views: 5232
|
|
|
DSCF0116
Date: 06/22/2009
Views: 4894
|
|
|
|
Starting Kitfox in -20C cold with coveralls on cowl and heat gun. Ethenol fuel of course.
Date: 01/31/2010
Views: 3951
|
|
|
InstrumentPanel73Ann
Date: 10/09/2004
Views: 4444
|
|
|
|
Condition Inspection P1 T
Date: 02/04/2010
Views: 4446
|
|
|
MG_1219
Date: 07/09/2006
Views: 5856
|
|
|
|
DSCF0019_1
Date: 07/02/2009
Views: 5390
|
|
|
P1001035
Date: 10/31/2008
Views: 10663
|
|
|
|
Using fore and aft the supplied by Europa for push-rod jam nuts that are .155" thick
Date: 12/13/2013
Views: 6843
|
|
|
DSCF0028
Date: 02/15/2009
Views: 7139
|
|
|
|
Unloading_after_flying_in_Potameo_LPPM_Portugal
Date: 06/29/2009
Views: 5343
|
|
|
DSCN8299
Date: 09/18/2010
Views: 7601
|
|
|
|
IMG_0838post
Put the plug back on the master cylinder.
Date: 01/22/2010
Views: 4307
|
|
|
DSC00228
Had to remove more of the rudder than I wanted so build up rudder trailing edge by attaching peel ply to the outside of the rudder and build up trailing edge using flox around the edge and an initial 2 ply of bid. i'll apply an additional 2 ply after the
Date: 09/10/2015
Views: 68502
|
|
|
|
IMG_0826
Date: 11/16/2005
Views: 5450
|
|
|
19092010483
Date: 09/19/2010
Views: 6859
|
|
