|
|
2012-08-18_19-58-42_666
Port side. Same area as before just without the flash. Backlit from the inside to show areas with less material. This is before I did the belly layup per the manual.
Date: 08/19/2012
Views: 22224
|
|
|
DSCF0016
Date: 06/19/2009
Views: 4720
|
|
|
|
S4
Date: 10/31/2008
Views: 6737
|
|
|
IMG_2267
Date: 02/23/2005
Views: 6889
|
|
|
|
DSCN4636Ann
Date: 08/05/2006
Views: 6007
|
|
|
GJ7I2380
Date: 07/09/2006
Views: 5232
|
|
|
|
A062403_Cockpit
Date: 12/31/1969
Views: 5036
|
|
|
Copy_of_Position_towertop
Date: 10/09/2003
Views: 7385
|
|
|
|
109_0937_IMG
Date: 01/11/2004
Views: 6521
|
|
|
BaggageBayBulkheadCut
Date: 06/20/2004
Views: 4771
|
|
|
|
Lower port 50p D-sub 90 degree connector 2.
Date: 08/31/2010
Views: 6113
|
|
|
IM002659
Date: 10/30/2007
Views: 10636
|
|
|
|
DSCN2268
Date: 03/18/2006
Views: 5519
|
|
|
RudderMount26Ann
Date: 07/01/2004
Views: 8229
|
|
|
|
Emergency Maneuver that starts with Heim? 5 of 13
Date: 12/16/2013
Views: 7587
|
|
|
IMG_1408
Still working on the brake plumbing. The translucent nylon was not fitting properly. Going back to the black stuff.
Date: 05/27/2011
Views: 6276
|
|
|
|
Orange part created in turbocad and printed on a 3D printer from ABS. Printer is a Prusa i3 X, cost is around $300.
Orange part created in turbocad and printed on a 3D printer from ABS. Printer is a Prusa i3 X, cost is around $300.
Date: 04/03/2016
Views: 30163
|
|
|
Tire mounting easier using clamps
Date: 02/18/2011
Views: 4244
|
|
|
|
IMG_2452
The Garmin equipment sold very quickly and the proceeds were used to buy the new instruments. Here are the 2 1/2" "backup" gauges with the Microair Comm & Xponder as well as the GRT EIS 4000 from the old panel. At this point I was sti
Date: 10/24/2011
Views: 7840
|
|
|
LowerFuselageAccessPlatesTestFit
Date: 09/22/2003
Views: 6050
|
|
