|
|
IMG_1738
Date: 07/12/2004
Views: 7070
|
|
|
IMG_3104ann
Date: 01/17/2009
Views: 6253
|
|
|
|
Rotax setup for certified 914s.
Date: 03/06/2007
Views: 12247
|
|
|
Fuel_System_01_001
Date: 06/08/2007
Views: 7493
|
|
|
|
IMG_6106post
Date: 08/09/2009
Views: 6054
|
|
|
IM003437
Date: 10/31/2007
Views: 9653
|
|
|
|
dscn1702
Date: 12/31/1969
Views: 4793
|
|
|
ch16_5a
Date: 12/31/1969
Views: 7881
|
|
|
|
Oil_Pan_input
I put two 1.25 inch holes on either side of the shark's tooth. They empty into a rectangular plenum about 4 X 2.5 that is terminated about 1/4 inch in front of the oil pan. The pan has cooling strips and the outside air contributes to oil cooling.
Date: 08/31/2011
Views: 251015
|
|
|
Sternpost port side trimmed before install 6.
Date: 11/06/2009
Views: 8651
|
|
|
|
Fin rib 1.
Date: 04/15/2009
Views: 8502
|
|
|
Mass_Balance_Tower_10
Date: 01/23/2006
Views: 5995
|
|
|
|
IMG_1592
Date: 06/08/2004
Views: 8762
|
|
|
Top bond on 1.
Date: 04/30/2009
Views: 5477
|
|
|
|
p1000634
p1000634.jpg
Date: 02/14/2012
Views: 12276
|
|
|
IMG_0858post
We also put the graphics on his aircraft.
Date: 01/22/2010
Views: 4656
|
|
|
|
dsc08625
Cutting out one of the ribs for the airframe. Going to use the mono trailer as the foundation of the jig. This will make is easy to level the airframe when getting ready for the trr-gear conversion. How do you like my work bench?
Date: 04/14/2012
Views: 32577
|
|
|
108_0818_IMG
Date: 10/12/2003
Views: 8265
|
|
|
|
DSC_0206
Date: 05/15/2008
Views: 5440
|
|
|
DSCN3587
Date: 12/31/1969
Views: 4667
|
|
