|
|
IMG_9572post
Made sure that the vent line was attached and run to the back and down into the area below the engine, but not into the air stream.
Date: 06/12/2010
Views: 5996
|
|
|
IMG_1389
Date: 02/05/2010
Views: 11315
|
|
|
|
IMG_0148
Date: 04/14/2005
Views: 5154
|
|
|
Cambridge
Cambridge
Date: 10/11/2011
Views: 7562
|
|
|
|
IMG_2437
Date: 10/09/2005
Views: 4400
|
|
|
DSCN6167Ann
Date: 06/24/2007
Views: 5352
|
|
|
|
Mass_Balance_Tower_39
Date: 01/23/2006
Views: 5054
|
|
|
IMG_0723
Date: 10/31/2005
Views: 4773
|
|
|
|
11072002133846_G
Date: 12/31/1969
Views: 3728
|
|
|
PitotStatic08
Date: 02/23/2003
Views: 6447
|
|
|
|
Rudder_the_5
Date: 05/23/2009
Views: 5531
|
|
|
IMG_7029
Supporting material in the form of rigid polyurethane sheet and micro/epoxy mix are laid out on the bottom of the fuselage.
Date: 10/31/2013
Views: 9370
|
|
|
|
IMG_1131
Date: 08/30/2007
Views: 5511
|
|
|
First pass of Port top wingskin bond on 4.
Date: 09/11/2010
Views: 6313
|
|
|
|
L_antenna_1
Date: 02/20/2009
Views: 7809
|
|
|
IMG_0002_001
Date: 05/06/2007
Views: 5829
|
|
|
|
Landing gear Failure could be caused by too much over center.
Date: 06/12/2011
Views: 3805
|
|
|
IMG_0873post
Then saw the drop on the engine mount cross-tube and saw more coming across the tube.
Date: 01/24/2010
Views: 5020
|
|
|
|
50_G
Date: 06/19/2009
Views: 4048
|
|
|
Rotax 914 TCU control wiring.
Date: 04/23/2009
Views: 10850
|
|
