|
|
IMGA0609
Date: 06/28/2014
Views: 99316
|
|
|
IMGA0820
Aileron closeout
Date: 05/15/2013
Views: 97619
|
|
|
|
IMGA0585
Date: 03/18/2013
Views: 96915
|
|
|
IMGA0605
Date: 06/25/2014
Views: 96665
|
|
|
|
IMGA0572
Date: 03/17/2013
Views: 96306
|
|
|
IMGA0878
Wing rib close outs
Date: 05/30/2013
Views: 95622
|
|
|
|
Elba LIRJ from 3000ft
Date: 06/07/2012
Views: 94756
|
|
|
DSC00219
bracket installed
Date: 09/09/2015
Views: 94695
|
|
|
|
IMGA0722
Just testing out the rear blocks for an idea what it will look like
Date: 04/24/2013
Views: 94655
|
|
|
IMGA1057
And a few hours later.......
Date: 08/09/2013
Views: 94633
|
|
|
|
20130902_132110
Date: 09/02/2013
Views: 94441
|
|
|
IMGA0573
Date: 03/17/2013
Views: 94063
|
|
|
|
Dubrovnik Croatia
Date: 08/14/2012
Views: 93984
|
|
|
IMGA0661
Screws through ribs to align blocks.....must remember to remove them before the lay up
Date: 04/17/2013
Views: 93664
|
|
|
|
IMGA0932
Date: 06/01/2017
Views: 93611
|
|
|
IMGA0833
Remove trailing edge support ready for skin lay up
Date: 05/17/2013
Views: 93486
|
|
|
|
IMGA1030
Wing tips prepped for shaping thanks to Tony K's web blog on his kit #272
Date: 08/08/2013
Views: 93107
|
|
|
DSC00163
Rudder opened up to accept the push rod bracket. Alas no blue foam as it is the NG model. No instructions on how to proceed. Advice from Europa is to bod in some blue foam is it is not load bearing and is just a bed for the composite.
Date: 09/04/2015
Views: 93055
|
|
|
|
IMGA0581
Date: 03/18/2013
Views: 93015
|
|
|
IMGA0750
Made a tube of bid to carry the pitot tubes from one block to another. This block is where the bell crank sits and the push rod goes to the aileron.
Date: 05/05/2013
Views: 93002
|
|
