|
Door handel alignment to door 2
Date: 10/25/2009
Views: 4183
|
|
|
Aft sill cover 8.
Date: 08/31/2010
Views: 2786
|
|
|
IMG_1469p
Cleaned up the tunnel area.
Date: 06/05/2011
Views: 2916
|
|
|
108_0817_IMG
Date: 10/12/2003
Views: 3646
|
|
|
DSCN8284
Date: 09/18/2010
Views: 3326
|
|
|
IM003637
Date: 11/25/2007
Views: 3272
|
|
|
Tailplane_67
Date: 01/23/2006
Views: 2072
|
|
|
IMG_6297
The ease of getting the engine is inversely proportional to the cost. Just fork out enough moolah to buy a normal family car and within a week the postman drops this on your doorstep.
Date: 11/26/2016
Views: 7835
|
|
|
IMG_8566
Date: 07/08/2014
Views: 4465
|
|
|
DSCF0022_1
Date: 07/02/2009
Views: 3082
|
|
|
IMG_3092
Date: 01/22/2011
Views: 7814
|
|
|
Flap drive pin install 9.
Date: 11/30/2010
Views: 3218
|
|
|
Starboard door fit, there are 2 clamps on hinge tangs holding door in place.
Date: 10/20/2009
Views: 2934
|
|
|
IMG_7539ann
Realizing that I'd need to do any remaining work at home, I removed the disk brake, gathered up the bits and headed for the shop. This is just a pic of the BSPT threaded hole in the disk brake. Had to clean it out as it was full of crap. Testing showed
Date: 04/18/2010
Views: 2869
|
|
|
Antenna_wired_1
Date: 05/03/2009
Views: 2904
|
|
|
IMG_3301post
The issue being the softness and flexibility of the gasket material. Makes it difficult to ensure proper location while reattaching the bowl. The gasket is probably fine for a carb rebuild where you are doing it on the bench and can turn the carb over f
Date: 06/01/2012
Views: 3865
|
|
|
IMG_0032post
Date: 09/01/2010
Views: 3477
|
|
|
IMG_7047Ann
Date: 03/28/2008
Views: 3347
|
|
|
IMG_0048post
Date: 09/01/2010
Views: 2759
|
|
|
ReinforceFirewall00Ann
Date: 06/03/2004
Views: 2851
|
|