|
|
First pass of Port top wingskin bond on 13.
Date: 09/11/2010
Views: 5347
|
|
|
1_snaps
The headrest snap bases for the seat back tabs were never done well by my upholstery guy. Just a skinny screw through the hole where a big rivet had been removed. And simple nuts on the underside.
Date: 06/23/2011
Views: 4498
|
|
|
|
dsc08640
OK not the best shot but here you can see I used the jack to move the rear rib in place under the airframe being careful not to pinch the belly. I then secured the rib in place but using some drywall screws in the 2x6. This way any weight will be transf
Date: 04/15/2012
Views: 23618
|
|
|
CH14_12
Date: 12/31/1969
Views: 4809
|
|
|
|
dsc08603
Since I'm going to have to remove the mono wheel I dont have much of an edge to close in the big hole in the bottom. I'll have a better look at it once its a tri-gear.
Date: 04/10/2012
Views: 30930
|
|
|
Port bracket, aft side of firewall.
Date: 01/25/2010
Views: 8038
|
|
|
|
IMG_8165Ann
Date: 07/14/2008
Views: 4325
|
|
|
B100904_wheelpants5
Date: 10/09/2004
Views: 4966
|
|
|
|
24_04_08_vliegfoto_s_043
Date: 04/26/2008
Views: 3097
|
|
|
Photo_052007_003
Date: 05/20/2007
Views: 3927
|
|
|
|
IMG_7943Ann
Date: 06/28/2008
Views: 4218
|
|
|
Fuel_system_16
Date: 07/01/2007
Views: 5513
|
|
|
|
Flap cross tube marking tool
Date: 08/04/2013
Views: 7124
|
|
|
DSCN5984Ann
Date: 05/04/2007
Views: 4187
|
|
|
|
DSCF0026_1_001
Date: 10/26/2009
Views: 5211
|
|
|
IMG_1566
Date: 06/07/2004
Views: 6160
|
|
|
|
IMG_3278
And the float bowl back in place, with no gasket sticking out anywhere. Then it was torqued down and safety wired. Both drip trays were then re-installed. Lastly, I ran the electric fuel pump for several minutes (at 6 PSI according to the gage) and che
Date: 05/30/2012
Views: 6495
|
|
|
A042003_Pocket
Date: 12/31/1969
Views: 4131
|
|
|
|
DSC00083_Texted
Date: 12/31/1969
Views: 4796
|
|
|
IM003632
Date: 11/24/2007
Views: 6836
|
|
