|
dsc08664
The gell coat really gums up the sand paper. Still a bit more to remove.
Date: 04/22/2012
Views: 11877
|
|
|
photo (2)
Small area to work in. Back was killing me after that job. can't wait to give my back the same treatment when doing the ribs and starboard side.
Date: 08/20/2012
Views: 11873
|
|
|
20141102_161036
Everything looking good.
Date: 11/02/2014
Views: 11831
|
|
|
20160403_160443.jpg
20160403_160443.jpg
Date: 04/03/2016
Views: 11759
|
|
|
Close up of the relief cut.
Close up of the relief cut.
Date: 04/03/2016
Views: 11628
|
|
|
Actual part.
Actual part.
Date: 04/03/2016
Views: 11611
|
|
|
p1000476
p1000476.jpg
Date: 12/13/2011
Views: 11601
|
|
|
dsc08611
Unused Mono wheel components. I'll probably be selling these soon.
Date: 04/10/2012
Views: 11519
|
|
|
This is the printer part showing the parts in place.
This is the printer part showing the parts in place.
Date: 04/03/2016
Views: 11474
|
|
|
p1000472
p1000472.jpg
Date: 12/13/2011
Views: 11463
|
|
|
20160403_160502.jpg
20160403_160502.jpg
Date: 04/03/2016
Views: 11183
|
|
|
photo (1)
Bad pic, but shows the end of the reinforcement layups (port side).
Date: 08/20/2012
Views: 11160
|
|
|
20141102_161049
20141102_161049.jpg
Date: 11/02/2014
Views: 11127
|
|
|
E2
Date: 10/05/2012
Views: 10955
|
|
|
dsc08662
The 10“ diameter from the pilot hole.
Date: 04/22/2012
Views: 10944
|
|
|
dsc08609
Underside of vents.
Date: 04/10/2012
Views: 10868
|
|
|
dsc08608
These will have to go. They are on top and I will remove them and put one vent on the bottom.
Date: 04/10/2012
Views: 10700
|
|
|
DSC08796
Put in the panel to dream a little. Don't really know what I'm going to do. Was thinking of keeping it low cost for the first panel and keeping it analog until I can get the cash mula for something better like glass/IFR. Also want to fill the hole where
Date: 06/05/2012
Views: 10534
|
|
|
dsc08661
Locating the center of the main gear hole. Used a pilot to be used to measure out the 10“ diameter on the bottom.
Date: 04/22/2012
Views: 10407
|
|
|
p1000471
p1000471.jpg
Date: 12/13/2011
Views: 10405
|
|