|
Front Cable Mount with Lever in Down Position
Date: 12/12/2013
Views: 3321
|
|
|
Cut down Heims to 1.700"
Date: 12/13/2013
Views: 3656
|
|
|
1/8" 4130 bracket
Date: 11/27/2013
Views: 3199
|
|
|
Washers countersunk and screws shouldered
Date: 12/31/2013
Views: 4723
|
|
|
A Flap Push-Rod is not going to work post Mod 78
Date: 11/27/2013
Views: 2867
|
|
|
The center hole was tapped and used for 1st test mount, a big lightening hole will eliminate it
Date: 11/27/2013
Views: 3617
|
|
|
Heims overall length cut down to 1.700"
Date: 12/16/2013
Views: 3281
|
|
|
Front HardPoint 8
Date: 12/27/2013
Views: 4966
|
|
|
Mill round slot in master cylinder 2 of 2
Date: 12/24/2013
Views: 6493
|
|
|
Here's my extra deflection
Date: 11/27/2013
Views: 3071
|
|
|
Two forward and one aft 11/16 nuts get weight reduction
Date: 12/16/2013
Views: 3579
|
|
|
Air-brake cables were used to determine feasibility and length needed
Date: 11/27/2013
Views: 4207
|
|
|
I will leave ~ 1.25 diameters of thread engaging and remove all else
Date: 12/13/2013
Views: 3257
|
|
|
Mill round slot in master cylinder 6 of 12
Date: 12/23/2013
Views: 4242
|
|
|
Front HardPoint 3
Date: 12/27/2013
Views: 4576
|
|
|
1/2" clamps that allow cable to slide 1 of 2
Date: 12/16/2013
Views: 4672
|
|
|
Checking Flap Throw 1
Date: 12/12/2013
Views: 3147
|
|
|
Eric Engineering bending moment of tube with bends
Date: 12/03/2013
Views: 3840
|
|
|
Mill round slot in master cylinder 11 of 12
Date: 12/24/2013
Views: 5677
|
|
|
Front Cable Mount with Lever in Up Position
Date: 12/12/2013
Views: 3542
|
|