|
IMG_1233ann
Went home and pulled a brake caliper off my Little Toot project. Brought it out to the hanger and the darn thing fits. So I have ordered a single puck version of the same brake caliper. When it arrives, it will go on and I'll replace the banjo hose end
Date: 06/21/2010
Views: 2610
|
|
|
IMG_6967post
Starboard side juncture of main beam with cross beam.
Date: 12/27/2009
Views: 2575
|
|
|
IMG_6788post
Length of the cross I-beam
Date: 12/10/2009
Views: 2941
|
|
|
IntercoolerKit01
Date: 12/08/2004
Views: 3934
|
|
|
IMG_0888post
This is the Grove brake caliper I am using. It may not be the perfect replacement for the Europa brake but it sure works. I've e-mailed Robby at Grove and asked if he'd like me to send the old Europa brake caliper to see if they have a better replacemen
Date: 06/29/2010
Views: 2682
|
|
|
DSCN6115Ann
Date: 06/14/2007
Views: 3049
|
|
|
IMG_0037
More retraction tests. Closer, but still won't quite go into up lock. Maybe 1/4" (0.635 cm) from engaging. Back under for a couple more hours before I finally see where the blue from the fitting is rubbing on the side of the tunnel where the seat
Date: 07/07/2010
Views: 2820
|
|
|
DSCN6107Ann
Date: 06/13/2007
Views: 2742
|
|
|
IMG_2855
Date: 12/03/2008
Views: 3205
|
|
|
IMG_1238ann
The vent port was reversed from the original regulator. This one points forward. Had to do some tugging on tubing to get it all arranged. As soon as I have my new brake caliper installed and tested, I'll be ready to start testing the engine.
Date: 06/21/2010
Views: 2949
|
|
|
DSCN6118Ann
Date: 06/14/2007
Views: 2806
|
|
|
IMG_7441post
Here's a look at the tubing end of the two fittings. Again, similar, but not the same. Can't use the original fitting with the new tubing.
Date: 03/19/2010
Views: 2487
|
|
|
DSCN6092Ann
Date: 06/12/2007
Views: 3275
|
|
|
DSCN6155Ann
Date: 06/18/2007
Views: 3076
|
|
|
IMG_6687Ann
Date: 02/15/2008
Views: 3766
|
|
|
DSCN6093Ann
Date: 06/12/2007
Views: 3698
|
|
|
Seat_Back
Date: 04/19/2006
Views: 3881
|
|
|
IntercoolerFig3
Date: 01/07/2006
Views: 3863
|
|
|
Urear
Date: 04/16/2006
Views: 3759
|
|
|
1_snaps
The snap bases for the seat back cushions were poorly installed by my interior guy. Just a skinny screw through the over-sized hole the snap base where the original rivet went.
Date: 06/23/2011
Views: 3961
|
|