|
CH29_24
Date: 08/07/2005
Views: 3544
|
|
|
IMG_0727
Date: 11/02/2005
Views: 2725
|
|
|
dsc08399
Atempting to remove the mass ballance brace but to only find out later that it is bonded at the top.
Date: 03/25/2012
Views: 8528
|
|
|
IM003644
Date: 11/25/2007
Views: 3733
|
|
|
IMG_7429post
Here's a closeup of the hose end, bolt and washers. The hose end connector is identical to that which was on the master cylinder end so this should easily replace the 90 degree AN hose end provided. We'll know better later this week when I can get to th
Date: 03/15/2010
Views: 2519
|
|
|
DSC00070
Date: 12/31/1969
Views: 3353
|
|
|
010702_counter_boring_tool
Date: 12/31/1969
Views: 2601
|
|
|
FuelSystemMod49Ann
Date: 05/05/2004
Views: 2150
|
|
|
Internal_bracket_close_up
Date: 09/02/2004
Views: 4514
|
|
|
DSCF0025
Date: 06/19/2009
Views: 4197
|
|
|
DSC_0222
Date: 05/15/2008
Views: 2677
|
|
|
Tie-bar 36.
Date: 11/16/2010
Views: 3349
|
|
|
DSCN6348
Date: 10/11/2009
Views: 2547
|
|
|
Rumble_Seat
Date: 12/31/1969
Views: 3279
|
|
|
SingletonMod03
Date: 02/01/2004
Views: 3108
|
|
|
IMG_3301post
The issue being the softness and flexibility of the gasket material. Makes it difficult to ensure proper location while reattaching the bowl. The gasket is probably fine for a carb rebuild where you are doing it on the bench and can turn the carb over f
Date: 06/01/2012
Views: 3500
|
|
|
P1210017
Date: 01/21/2006
Views: 3459
|
|
|
Single_man_rigging_DSC00137_jpgUnder_wing_side_of_clamp
Date: 08/13/2005
Views: 3456
|
|
|
DSCN5598Ann
Date: 03/05/2007
Views: 2873
|
|
|
Fuse fill 1.
Date: 09/14/2009
Views: 2371
|
|