|
Fuel_System_07
Date: 01/23/2006
Views: 5321
|
|
|
dscn0972
Date: 12/31/1969
Views: 2456
|
|
|
IM003433
Date: 10/31/2007
Views: 3586
|
|
|
IMG_0221
Date: 04/14/2005
Views: 2831
|
|
|
IMG_0334Ann
Date: 05/31/2008
Views: 2988
|
|
|
second_flight_5
Date: 07/19/2007
Views: 2562
|
|
|
IMG_1418ann
I had also been working on a stainless steel cover/mount which attaches to the lower firewall and will support the front edge of the monowheel hole cover.
Date: 12/20/2010
Views: 2873
|
|
|
DSC00876
Date: 04/15/2005
Views: 2736
|
|
|
Tailplane_75
Date: 01/23/2006
Views: 1843
|
|
|
DSCN8245
Date: 09/18/2010
Views: 2584
|
|
|
IMG_7441post
Here's a look at the tubing end of the two fittings. Again, similar, but not the same. Can't use the original fitting with the new tubing.
Date: 03/19/2010
Views: 2504
|
|
|
Door sill conduit run 33.
Date: 08/15/2010
Views: 3408
|
|
|
IMG_2692
The longest AN3-30 bolt I had was too short so a longer bolt is on order as are aluminum spacers to maintain proper alignment of the ends of the MCs.
Date: 04/09/2012
Views: 2760
|
|
|
Starboard_panel_windscreen_joint_Y9_06_07
Date: 06/07/2009
Views: 2798
|
|
|
IMG_0710
Date: 05/30/2009
Views: 4116
|
|
|
Gear lever hardware too close to module 2.
Date: 01/17/2010
Views: 5198
|
|
|
Ant_1
Date: 02/11/2009
Views: 3622
|
|
|
nex_2013_08_24_04
As you see here the port side is done with rib 3 and 4. I didn't have photos of doing the layups.
Date: 08/25/2013
Views: 6173
|
|
|
011602_outboard_flap_pivot
Date: 12/31/1969
Views: 2550
|
|
|
DSCN5151
Date: 11/29/1999
Views: 3143
|
|