|
17102009375
Date: 10/17/2009
Views: 4386
|
|
|
121502_fuseblock
Date: 12/31/1969
Views: 2794
|
|
|
A062403_Two_7
Date: 12/31/1969
Views: 2851
|
|
|
IMG_2706
Assembled everything. You can see the spacers fit to hold the master cylinders in alignment. Plumbing in place. The unit is about 1 1/2 in. taller than the old Jaymar. I'm wondering if it will fit or will I have to lower it in the mount? We'll see to
Date: 04/11/2012
Views: 3404
|
|
|
IM003052
Date: 10/30/2007
Views: 3976
|
|
|
109_0919_IMG
Date: 01/06/2004
Views: 2987
|
|
|
109_0991_IMG
Date: 02/03/2004
Views: 2825
|
|
|
A012203_DigiTrack1
Date: 12/31/1999
Views: 2685
|
|
|
IMG_1143
Date: 08/30/2007
Views: 2391
|
|
|
IMG_7441post
Here's a look at the tubing end of the two fittings. Again, similar, but not the same. Can't use the original fitting with the new tubing.
Date: 03/19/2010
Views: 2512
|
|
|
IMG_6140post
Date: 08/09/2009
Views: 2578
|
|
|
Photo_051307_002
Date: 05/13/2007
Views: 2446
|
|
|
DSCN6324
Date: 10/11/2009
Views: 2245
|
|
|
Panel mounted after upper right side was buttered with Flox/Q-Cel.
Date: 01/15/2010
Views: 3302
|
|
|
Brackets are mounted. Wayne is about half way done with PCB.
Date: 07/15/2010
Views: 3023
|
|
|
Baggage_Area_03_001
Date: 06/03/2007
Views: 3059
|
|
|
DSCN4661Ann
Date: 08/20/2006
Views: 2554
|
|
|
67_throttle_lever
Date: 12/31/1969
Views: 3194
|
|
|
AftAccess02
Date: 03/18/2004
Views: 3123
|
|
|
IMG_7384ann
The threads on both fittings are 24/in. So that's a match. The issue is one is straight and the other pipe thread.
Date: 03/07/2010
Views: 2771
|
|