|
Air-brake cables were used to determine feasibility and length needed
Date: 11/27/2013
Views: 4244
|
|
|
Igus bearings
Date: 11/27/2013
Views: 5267
|
|
|
Drill jig and plywood insert
Date: 11/27/2013
Views: 3273
|
|
|
You can see the locknut contacting
Date: 11/27/2013
Views: 3536
|
|
|
The shoulder of my spacers allows for a tiny bit more deflection than without
Date: 11/27/2013
Views: 3231
|
|
|
A Flap Push-Rod is not going to work post Mod 78
Date: 11/27/2013
Views: 2891
|
|
|
Just needs a pullin
Date: 11/27/2013
Views: 3868
|
|
|
Steel for front mount
Date: 11/27/2013
Views: 4775
|
|
|
Nice-a-fit!
Date: 11/27/2013
Views: 3104
|
|
|
OK, we are ready for in situation fitting to get correct length and angle of 1" tube
Date: 11/27/2013
Views: 3192
|
|
|
Igus bracket and spacers
Date: 11/27/2013
Views: 3136
|
|
|
1/8" 4130 bracket
Date: 11/27/2013
Views: 3234
|
|
|
1/4-28 jam nuts
Date: 11/27/2013
Views: 3148
|
|
|
Straight ahead
Date: 11/27/2013
Views: 3736
|
|
|
Here's my extra deflection
Date: 11/27/2013
Views: 3107
|
|
|
Drill jig
Date: 11/27/2013
Views: 3537
|
|
|
You really can't see with the pillow block in place, but lightening holes under contact area
Date: 11/27/2013
Views: 4358
|
|
|
The center hole was tapped and used for 1st test mount, a big lightening hole will eliminate it
Date: 11/27/2013
Views: 3656
|
|
|
Ready to install nut-plates
Date: 11/27/2013
Views: 4054
|
|
|
Nut-plates
Date: 11/27/2013
Views: 4273
|
|