|
dsc08966
Port side LG socket hole.
Date: 10/01/2012
Views: 9203
|
|
|
dsc08963
Port side. LG socket fitting.
Date: 10/01/2012
Views: 8114
|
|
|
dsc08964
Port side. Fitting of LG socket.
Date: 10/01/2012
Views: 7935
|
|
|
dsc08960
Stb side after layups and peel ply removed.
Date: 10/01/2012
Views: 10382
|
|
|
dsc08961
Stb side two layers bid 10" and 8" peel ply removed
Date: 10/01/2012
Views: 10098
|
|
|
dsc08962
Stb side. Need to do some clean up...
Date: 10/01/2012
Views: 10073
|
|
|
photo (2)
Small area to work in. Back was killing me after that job. can't wait to give my back the same treatment when doing the ribs and starboard side.
Date: 08/20/2012
Views: 11917
|
|
|
photo (1)
Bad pic, but shows the end of the reinforcement layups (port side).
Date: 08/20/2012
Views: 11186
|
|
|
photo
No pictures of the progress of putting in the LG layups on the port side. Here I am putting down the peel ply.
Date: 08/20/2012
Views: 13734
|
|
|
2012-08-18_19-58-42_666
Port side. Same area as before just without the flash. Backlit from the inside to show areas with less material. This is before I did the belly layup per the manual.
Date: 08/19/2012
Views: 10155
|
|
|
2012-08-18_19-58-15_689
Port side. Red highlighted area shows area with little reinforcement on inside. This is before I did the belly layup per the manual.
Date: 08/19/2012
Views: 9637
|
|
|
DSC08796
Put in the panel to dream a little. Don't really know what I'm going to do. Was thinking of keeping it low cost for the first panel and keeping it analog until I can get the cash mula for something better like glass/IFR. Also want to fill the hole where
Date: 06/05/2012
Views: 10572
|
|
|
DSC08800
starboard side
Date: 06/05/2012
Views: 8495
|
|
|
DSC08801
starboard side
Date: 06/05/2012
Views: 8429
|
|
|
DSC08799
Port side
Date: 06/05/2012
Views: 8264
|
|
|
DSC08797
Port side
Date: 06/05/2012
Views: 8454
|
|
|
me_europa
Me in front of my Uncles Europa Classic late 90's in Borrego Springs, CA.
Date: 05/22/2012
Views: 9467
|
|
|
dsc08662
The 10“ diameter from the pilot hole.
Date: 04/22/2012
Views: 10982
|
|
|
dsc08664
The gell coat really gums up the sand paper. Still a bit more to remove.
Date: 04/22/2012
Views: 11917
|
|
|
dsc08661
Locating the center of the main gear hole. Used a pilot to be used to measure out the 10“ diameter on the bottom.
Date: 04/22/2012
Views: 10433
|
|