Rigging descision 2.5 Starboard, 2.4 Port and droop port flap .110 at root 1.
Date: 10/25/2010
Views: 3061
Mixing stick sanding board 2.
Date: 10/05/2010
Views: 5114
Newest Image
EAA SITE
Date: 08/23/2023
Views: 213394
IM003255
2 BID added to spread load to 2 hinges. Side note to Conventional taildragger (could have been a Mono) that came to Rough River 2007, your lower hinge area was cracking, you left before we had a chance to tell you.
Another note is when strengthening lower 2 hinge areas, because of 2 BID on the inboard side of flange and a piece of 1/16" thick G-10, rudder is offset outboard by about 1/8" which will cut bout half of fill needed on starboard side to somewhat match vertical fin. 1/8" thick G-10 spacing was needed under middle and top hinge to match hinge line.
Y9-04-05