The mold will need to be faired into the sill conduit allowing for a small access cover, (to allow wire routing forward, aft and up through the plastic conduit that goes to the ceiling on both sides of the plane).
In addition on this starboard side the front portion will need to turn upwards.
We're going to wait on the front portion until we have most of the wires run to figure out the optimal size, shape and design. We may consider adding an access cover up front if the wiring dictates so.
I just can't seem to get away from sanding and filling, (as you can see in this pict!), I used a bit of our "getting too hard to work with" 3M Flowable finishing putty that just doesn't seem to flow too good anymore.
Y10-08-21