Marked area to be cut out after stabalizing with 4 more rivets.
Date: 07/19/2010
Views: 3008
Newest Image
EAA SITE
Date: 08/23/2023
Views: 166132
Warning board mounted, let the wiring begin.
The warning board is mounted and we are ready to start connecting wires to the 25 pin D-sub connector.
The headset speaker and mic shielded wires are also run and ready to be connected to their associated jacks.
Note that all wires on both sides of the warning board that had potential to move about are either held in place with Shoe-Goo, Kevlar thread or both.
The red and black wire snuck behind the circuit board and wound with Teflon spiral wrap is going to the siren.
Y11-01-01