Wing root fairing instructions for fitting Fred 10
Date: 02/15/2009
Views: 3261
imm035_36
Date: 09/02/2009
Views: 4040
IM003419
Date: 10/31/2007
Views: 5089
Newest Image
EAA SITE
Date: 08/23/2023
Views: 159137
Lengthening snap bushing 1.
Dug out a little foam in 5/16" hole, then cut two snap bushings where they fit together by removing 1/2 of a side. This leaves a nice rounded entry and exit. I didn't want to make a huge hole for rubber grommet. Wires going to reed switches will be 2 conductor shielded. Reason for shielding is for robustness. Snap bushings were floxed in place. By leaving 1/2 remaining on each side, there was 1 snap that will get nice and stuck once flox cures.
Y10-06-13